ETA Elance - Manual (Page 25)

v. MAINTeNANCe
Unplug the battery charger from the appliance before any maintenance. Store the vacuum
cleaner at a dry place, far enough from heat sources (e.g. fireplace, stove, heating
element) and protect it against weather conditions (e.g. rain, sunshine). Treat the surface
of the vacuum cleaner and the battery charger (only when disconnected from the electric
socket) with a soft and wet cloth, do not use abrasive and aggressive cleaning agents! Never
dry plastic moldings over a heat source (e.g. heater, electric/gas stove).
Floor nozzle with rotation brush
After any vacuuming it is recommended to check visually the brushes or collectors for possible
impurities. If you find some impurities, remove them in the way specified below. Cut threads
and hair with scissors and remove them. If hair or threads are twisted around the mounting of
the drive shaft and if they cannot be removed in the way described above, the impurities have
to be removed by dismantling the nozzles. Unscrew the bolt in the lower part and remove the
cover (Fig. 5). Bend the locking cog with a suitable tool (e.g. a flat screwdriver). Now you can
remove the brush from its position and clean it. Insert the brush to the nozzle in the opposite
direction (you will hear a snapping sound) and secure it properly with a lid.
Storage
Store the appliance thoroughly clean on a dry, dustless place out of reach of children and
persons sui juris. The accessories may be stored in the back of the charging stand C or in
the storage space C1 (Fig. 6). Do not put the assembled rod vacuum cleaner on an uneven
surface! The cleaner must be placed on a flat surface where there is no danger of knocking
over.
VI. TROUBLESHOOTING
Problem Cause Solution
Motor won‘t start The battery is discharged
A1/B1
button is not
switched on
Recharge the battery
Push A1/B1 button
The container
cannot be fixed
to the vacuum
cleaner
The parts of the filtration
system not inserted
properly in the container
Check/correct insertion of the
protector and the micro-filter in the
container
Suction output is
not sufficient
Dust container full
Clogged filter protector
Clogged micro-filter
The accessories are
clogged
The battery is discharged
Empty the container
Clean the protector
Clean or replace the micro-filter
Remove blocking objects
Recharge the battery
Nozzle with
rotation brush
does not work
Rotation brush is blocked Remove blocking objects
25
GB
/ 42