ETA Elance - Manual (Page 23)

Floor nozzle with rotation brush
Slide the nozzle D into the vacuum cleaner body B all the way (you’ll hear an audible
clack). Take the nozzle off reversely (pic. 2B). Make sure that both the switches A1 and B1
are off before any manipulation with the rotation brush.
Slit nozzles
Slide the selected accessory E all the way into the opening in the dust bin A5. Take the
attachment off reversely. The accessory can be used only with this vacuum cleaner.
Battery charging
Before the first use, the battery has to be charged for at least 12 hours. Plug battery
charger F to the electric socket. Push the adapter connector into the slot C2 in the charging
stand. (Fig. 3). The operation of charging of the accumulator is indicated by the “red”
indicator D1. The indicator will turn green when the battery is fully charged. After about 6
to 8 hours, the battery is usually fully charged and it enables operation for about 20 to 25
minutes (depends on method of vacuuming).
CAUTION
– If you charge the battery for the first time or after long storage, about 60 % of its total
capacity is charged. After repeated discharge and repeated recharge the battery is
fully charged.
– After completing hard work or in hot environment, the battery may be too hot for
charging. Let the battery cool down before charging.
– Do not use the vacuum cleaner during charging.
– For ensuring longer life of the battery we recommend full discharge and then full
recharge of the battery four times a year.
– The vacuum cleaner can be charged only in one piece with the floor nozzle D placed in
the stand.
!
Iv. use oF vACuuM CleANeR
According to the selected cleaning activity, use either the vacuum cleaner alone and
select accessory E or assemble the vacuum cleaner with an extension adapter and select
accessory D. The floor nozzle with a rotation brush D is intended for vacuuming carpets
with low pile or smooth flooring. You can use crevice nozzle E1, E2 for vacuuming places
that are hard to access. In case of using the cleaner A without the body of the rod cleaner
B, turn it on/off by pressing the switch A1. If you will be using the cleaner assembled, you
can turn it on/off with the switch B1. When control light D1 is on, it signals operation of the
rotation brush.
Let the vacuum cleaner recharge as soon as its suction performance gets weaker.
In the case of everyday use, do not disconnect the battery charger from the electric socket.
In this way the appliance will always be fully loaded. Battery overcharging is not possible.
If you are not present for longer time (more than one day), remove the charger from the
electric socket to save energy.
23
GB
/ 42