ETA Andare Animal User Manual

Page 22

IV USING THE VACUUM CLEANER

Remove all the packing material, take out the vacuum cleaner and the accessories.

Pull out the necessary length of power cord

A7 and plug the power cord into a socket.

Assemble the vacuum cleaner accessories

C1, C2, C3 (Fig. 2, 3, 4). If the cleaner is fitted

with telescopic tube

C3, adjust its length to fit your figure (Fig. 5). Floor nozzle C1

is designed to be used to clean carpets or smooth flooring (Fig. 6). If the floor nozzle is

fitted with the brush, pull it out by switching the flap when vacuuming hard floorings. You

can use crevice nozzle

C6 for vacuuming places that are hard to access (Fig. 7). Narrow

TURBO nozzle

C9 or upholstery nozzle C4 or brush C5 can be used to clean various types

of furniture (Fig. 8, 9). The vacuum cleaner can be switched on or off by pushing button

marked with the symbol „

„ (Fig. 10). The suction power can be adjusted by the control

on hose handle

C2 (Fig. 11) or by setting control A5 (Fig. 10). The minimum suction power

is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power

is recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, switch

off the vacuum cleaner and unplug it from the power supply. By pressing button

A3 with

the symbol „

“ (Fig. 10), the power cord is wound automatically. The vacuum cleaner

can be held and carried by handle

A8.

Full dust container indicator

If the coloured field is displayed permanently on indicator

A4 while the floor nozzle is lifted

above the cleaned surface at

maximum suction power (Fig. 12), the dust container must

be emptied. Disregard changes on the indicator during vacuuming.

Emptying the dust container

Press container lock button

A6 and then remove container B from the vacuum cleaner

(Fig. 13). Put the container above a dust bit and press button

B2; thus you will lift off

bottom

B3 and throw the dust in common municipal waste (Fig. 14). Snap the bottom shut

to secure it and insert the container into the vacuum cleaner in the opposite direction. For

sanitary reasons we recommend emptying the container outside housing premises.

Cleaning the dust container, micro-filter and HEPA filter

After about 5 emptying of the container we recommend complete cleaning of the filtration

system to remove the settled dust.

B6 separator: push button B2, thus you will lift off bottom B3, and you can release the

separator by turning it towards the UNLOCK sign, and then take it out by

pulling (Fig. 15).

- Foam micro-filter

B4: pull it out of the container (Fig. 16).

- HEPA filter

B5: pull it out of the container (Fig. 16). Tap the dust out of the filter over a

dustbin or to clean the filter through a blowing (we recommend the filter

cleaning outside of living area for hygiene reasons). If the protection micro

filter is very dirty, you can also rinse the pleated side of the HEPA filter

under lukewarm slow-running tap. Hold the filter in such a way that the

pleated side points upwards and the water flows parallel to the pleats.

Hold the filter at an angle so that the water washes away the dirt inside

the pleats. Turn the filter 180° and let the water flow along the pleats in

the opposite direction. Continue this process until the filter is clean. After

drying, insert the cartridge back to the vacuum cleaner in the opposite way.

22 / 39