ETA Andare Animal User Manual

Page 21

– The manufacturer is not responsible for damage caused by improper use of the appliance

and the accessories and its guarantee for the appliance does not apply in situations when

the safety warnings above are not complied with. Failure to replace or maintain all filters

regularly according to the instructions in Chapter

IV. USING VACUUM CLEANER and

also using non–original filters, the properties of which resulted in failure or damage of the

vacuum cleaner is also understood to be improper use of the appliance.

II EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER ETA – 1493/10 (Fig. 1)

A – vacuum cleaner

A1 – suction vent

A7 – power cord

A2 – START/STOP button

A8 – holder

A3 – power cord winding button

A9 – exhaust filter

A4 – full container indicator

A10 – exhaust cover

A5 – electric motor regulation

A11 – parking hole

A6 – container lock button

B – dust container

B1 – holder

B4 – foam micro–filter

B2 – bottom lock button

B5 – HEPA filter

B3 – bottom flap

B6 – separator

C – accessories

C1 – floor nozzle

C5 – brush

C2 – suction hose

C6 – crevice nozzle

C3 – suction tube

C7 – accessories holder

C4 – upholstery nozzle

C8 – TURBO nozzle

C9 – narrow TURBO nozzle

III. PREPARING THE VACUUM CLEANER

Hose

– Connect hose

C2 to the vacuum cleaner by inserting the end piece to suction vent A1 to

the maximum position (Fig. 4). You will hear a clicking sound.

– Disconnect the hose by pressing the button on the end piece and pull the hose out

slightly.

Telescopic tube

– You can connect tube

C3 with hose handle C2 by slight pushing the handle to the tube

(Fig. 3).

– You can disconnect the tube by pulling the handle slightly out of the tube.

– The telescopic tube allows setting the suitable length according to your figure. Press the

lock pin in the direction of the arrow and pull out or push in the required length of the tube

(Fig. 5). When you release the lock pin, the tube length is fixed. When pulling out, keep

the tube in the safe distance from your face as the tube is very long.

Floor nozzle / TURBO nozzle / narrow TURBO nozzle

– Connect and disconnect the accessories (

C1, C8, C9) in the same way as the tube

(Fig. 2).

Upholstery/crevice nozzle, joint brush

– Connect and disconnect the accessories (

C4, C6, C5, ) in the same way as the tube

(Fig. 3).

21 / 39