ETA Novel - Manual (Page 29)

Remaining accessories, the floor nozzle, the suction tubes and the hose can be dismantled
again or left assembled and hung into parking holes A24 on the back side or on the bottom
of the vacuum cleaner into the storage position (in horizontal position, it is possible to only
hang the floor nozzle, in vertical position the telescopic tube with an attached nozzle). For
better stability, slide individual parts of the tube to each other so that the tube is as short as
possible. When storing, always set the floor nozzle to the carpet position (i.e. with the brush
retracted); thus you will prevent bending of the bristles.
V. MAINTENANCE
Store the vacuum cleaner at a dry place, far enough from heat sources (e.g. fireplace,
stove, heating element) and protect it from weather conditions (e.g. rain, sunshine).
Treat surface of the appliance with a soft and damp cloth, do not use coarse and aggressive
detergents! Store the appliance properly cleaned at a dry, dust-free place out of reach
of children and incapacitated people.
Floor nozzle
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Cleaning the TURBO nozzle
If hair or threads are twisted around the mounting of the drive shaft and if they cannot be
removed in the way described above, the impurities have to be removed by dismantling the
nozzles. In the lower part remove the cover. Now you can clean the nozzle using a suitable
tool (eg tweezers). Insert the lid to the nozzle in the opposite direction (you will hear
a snapping sound).
VI. TRoUbLESHooTING
Problem Cause Solution
Motor won‘t
start
Power supply not connected Check the cord, plug and the socket
button is not switched on Push button
Lid cannot
be closed -
safety lock
activated
Dust filter inserted incorrectly in the
holder / adapter
Check / repair fastening of the
cardboard front in the holder / adapter
Holder inserted incorrectly in the
suction space of the vacuum cleaner
Check / repair insertion of the holder in
the suction space of the vacuum cleaner
Suction
output is not
sufficient
Regulation in MIN position Set regulation to MAX.
open suction Close the hole in the hose handle
Dust filter full Replace the filter
Clogged micro-filters Replace micro-filters
Nozzle, suction hose or tube is clogged Remove blocking objects
The cable
cannot be
wound in the
entire length
Twisted cable Straighten the cable
Take out about 50 cm of the cable
and push again button
22
GB
/ 39