ETA Novel - Manual (Page 27)

Floor nozzle, TURBO nozzle
– Connect and disconnect the accessories ( B1, C4) in the same way as the tube.
Crevice/upholstery nozzle, brush
– Connect and disconnect the accessories ( C1, C2, C3) in the same way as for the tube.
You can connect the appliance directly to the hose handle or to the telescopic tube.
IV. USE oF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A23 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories. If the type of the vacuum cleaner is fitted with telescopic tube
B3, adjust its length to fit your figure (Fig. 6). Floor nozzle B1 is designed to be used to
clean carpets or smooth flooring (Fig. 7). If the floor nozzle is fitted with a brush, pull it out
by switching over a flap when vacuuming hard floorings. With nozzle C3 you can vacuum
places that are hard to access (Fig. 8). Separate upholstery nozzle C1 or the upholstery
nozzle with brush C2 (Fig. 9) can be used to clean various types of furniture (Fig. 10, 11).
The vacuum cleaner can be switched on or off by pushing button A7 marked with symbol
(Fig. 13). When control light A10 is on, it signals that the vacuum cleaner is in operation.
You can control suction output by regulation on the handle of hose B2 (Fig. 12) or by
repeated pushing or holding buttons A9 „
-
“, „
+
“ (Fig. 14). The minimum suction power
is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power is
recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, unplug the
vacuum cleaner from power supply. By pressing button A8 with the symbol (Fig. 15),
the power cord is wound automatically. The vacuum cleaner can be held and carried using
holder A12 in horizontal position or using a part adapted for vertical position (Fig. 28, 29).
Full dust filter signaling
If signaling A11 is displayed permanently (flashing) while the floor nozzle is lifted above
the cleaned surface at maximum suction power, the dust filter must be replaced (Fig. 16).
Disregard changes on the indicator during vacuuming.
Dust filter replacement
Lift off vacuum cleaner lid A3 by pushing lock A4 to the locked position (Fig. 17). Hold filter
holder A17 and remove it from the suction space by pulling it (Fig. 18). By lifting off lock
stop A18, dust filter A19 will be released from the holder / adapter (Fig. 19). Then follow the
instructions for the respective type of a dust filter:
Paper / synthetic / textile: put a new dust filter to the holder so that the edge with two
apertures in the cardboard front of the filter snaps behind the
projections, then tilt lock stop A18 and push the cardboard front of
the filter to the contact surface (Fig. 20), then release the lock stop.
UniBag: slide the projections on the front of a new dust filter into the holes in adapter A13
and secure the front by slight pushing (Fig. 20). You will hear a clicking sound.
Check proper fastening of the front by slight pulling of the dust filter. Slide the holder with the
filter to suction space and push it to the maximum position. Close the vacuum cleaner lid by
snapping it shut. You will hear a clicking sound.
20
GB
/ 39