Delta 28-348 - Manual (Page 10)

10
TOP PLATE TO CABINET
NOTE: IF YOUR MACHINE IS SUPPLIED WITH AN
LVC STARTER BOX, PLEASE REFER TO THE
SUPPLEMENTAL INSTRUCTION SHEET FOR
MOUNTING THE LVC BOX TO THE STAND. THEN
PROCEED AS FOLLOWS.
1. Place the top plate (A) Fig. 10, on the top of the
cabinet (B). NOTE: PLACE THE SWITCH CORD (F)
FIG. 10, THROUGH THE SLOTTED HOLE (G) IN THE
TOP PLATE (A) AND INSERT PLASTIC BUSHING (H)
INTO THE SLOTTED HOLE (G).
2. Align the six square holes on the top plate (A) Fig.
10, with the holes in the cabinet (B).
3. Align the two square holes on the side of the plate
(A) Fig. 10, with the two holes on the side of the cabinet
(B).
4. Insert 5/16-18x3/4" carriage head bolts through the
top plate and the cabinet. Thread 5/16-18 flange hex
nuts on to screws.
5. Make sure the door opening is at least 13" wide
before tightening the screws. If the door opening is not
at least 13" wide, spread the door opening and tighten
the hardware when the opening is at least 13" wide.
Fig. 10
DUST CHUTE
1. Insert the dust chute from inside the stand through
the opening (A) Fig. 11, in the top of the stand.
NOTE: MAKE SURE THAT THE MOTOR CORD IS
BEHIND THE DUST CHUTE.
NOTE: MAKE SURE THE TAB (B) FIG. 12, ON THE
DUST CHUTE, ENGAGES THE CUTOUT (C) IN THE
TOP OF THE STAND.
2. Align the two slotted holes (D) Fig. 13, in the bottom
of the dust chute with the two holes (E) Fig. 14, in the
stand.
Fig. 11
Fig. 12
Fig. 14 Fig. 13
E
A
B
F
G
H
A
B
C
D