Elfa Artic sloped - Manual (Page 2)

www.elfa.com
Page 2 of 4
4
3
5
6
Fit the LED light on sloped door (accessory)
When the top rail is in place, unroll the light strip. Remove the tape from the
back and attach the light strip in the top track rail. Plug straight into the wall
socket.
Assemble the top and bottom tracks
Follow the instructions in “Assembly guide for Ample, Artic, Grace
and Centric” to fit the top and bottom tracks.
Top track
Bottom track
Customer service / Kundendienst
Deutschland
Tel. 05242 3789375 Fax. 05242 9683632.
E-post:[email protected]
Service client
France
Tel. 472 330 731 Fax. 472 345 260
E-post:[email protected]
Serwis
Polska
Tel. 42 611 64 01 Fax. 42 611 64 02
E-post:[email protected]
Adjust the sloped door
Place the sloped door in the rear rail of the top and bottom tracks. Push
the door all the way against the wall. Hold the door in place and adjust the
bottom wheels according to the instructions in “Assembly guide for Ample,
Artic, Grace and Centric”. Lift out the door again.
Measure the
height H of the
upper edge of the
guide rail
Floor
H - 27 mm( fig
. 2 a)
or
H + 6 mm (fig
. 2 b)
Line
Mark the height of the guide rail
Measure the height H, to the upper edge of the guide rail (see fig. above).
Put the door on the floor with the front facing in to a wall. Measure from the
floor and up along each side profile to a measurement that matches H – 27
mm or H + 6 mm, depending on the interior (see fig 2a and 2b) . Connect
the points with a line across the back of the door (see fig. on the left).
The door may be slightly oblique when placed on the floor because of the
adjustment that was made to the wheels (see fig. on left). If it is, this is
perfectly correct and the line must still be measured upwards from the floor.
The wheel adjustment will not then affect the function of the guide rail when
the door is refitted in the bottom track
H - 27 mm( fig
. 2 a)
or
H + 6 mm (fig
. 2 b)
Sloped sliding doors
ASSEMBLY GUIDE