Elfa Top Track and hang standards - Manual (Page 2)

www.elfa.com
Sida 2 av 13
Top Track, Hardware and Hang Standards
Hardware for installation of Top Track
Make sure to use the appropriate hardware
based on what type of wall you have.
Expander for single plasterboard (G5)
Used for 1/2”/3 mm or 5/8”/17 mm thick
drywall. Use 3/8”/10 mm drill bit to drill hole. Insert
dark blue anchor, remove and discard the gray spacer.
Use #2 Phillips head bit to tighten the screw.
Screw and plug
Wood
Used for mounting into drywall over wood studs or
directly into wood. Use 1/8”/3 mm drill bit to drill a
pilot hole the length of the bit. Discard anchor. Use
#2 Phillips head bit to tighten the screw.
Concrete walls
Used for mounting into masonry walls, concrete,
brick, etc. Use 5/16”/8 mm masonry drill bit to drill
hole. Insert light blue anchor. Use #2 Phillips head
bit to tighten the screw.
Expander for double plasterboard (G6)
Used for 1”/18-30 mm thick plaster or drywall.
Use 3/8”/10 mm masonry drill bit to drill hole.Insert
red anchor, remove and discard the gray spacer.
Use #2 Phillips head bit to tighten the screw.
#2 bit
NOTE!
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: [email protected]