beautypg.com

Maintenance – Dixon ZTR34/968999619 User Manual

Page 42

background image

English

-

42

Deck belt removal

1. Park on a level surface. Apply parking brake.

2. Lower the deck into the lowest cutting

position.

3. Remove bolts from belt shields and remove

shields.

4. Remove any dirt or grass that may have

accumulated around the cutter housings and
entire deck surface.

5. Carefully roll the belt over the top of the

cutter housing pulleys and remove belt.

Deck belt installation

NOTE: For ease in installing the deck belt, refer to
the routing decal on bottom of seat.

1. Wrap the deck belt around the electric clutch

pulley that is located on the engine shaft.

2. Route the belt forward between the EZT (E-

Series Zeroturn Transaxles) and up onto the
deck.

3. Place belt around spring loaded idler pulley.

4. Wrap the belt around the stationary idler

pulley and around the mandrel housings.

5. Push inward on the idler arm and carefully

route belt over stationary idler pulley. Once
belt is properly routed, slowly release idler
arm to tension belt.

6. Double check belt routing to make sure it

matches the routing decal, and the belt does
not have any twist. Correct as needed.

7. Adjust tension with deck eyebolt.

8. Replace belt shields on both mandrel

housings and secure with fasteners.

8050-773

1. Shield bolts
2. Belt shields
Removing deck belt

1

2

8050-773

1. Clutch pulley
2. Deck belt
Belt routing, deck belt

1

2

MAINTENANCE

This manual is related to the following products: