Controls – Dixon ZTR34/968999619 User Manual
Page 23
CONTROLS
English
-
23
12. Mower Deck Cut Height Lift Lever
Located to the right and front of the operator, the lift
lever controls the cutting height. The deck cutting
height is obtained by pressing the foot pedal forward to
lift the deck. To lower the deck, apply pressure to the
top side of the foot pedal and allow it to pivot while
depressing the trigger and moving the lever forward.
Set the desired cut height with pin.
The cutting height range is from 1½" (38 mm) to 5½"
(140 mm) in ½" (13 mm) increments. The heights are
measured from the ground up to the blade tip with the
engine not running.
8050-774
1. Lift lever
2. Trigger
3. Set pin
4. Foot pedal
Cut height lift lever and pedal
1
3
4
IMPORTANT INFORMATION
In order to obtain an even cutting height it
is important that the air pressure in all four
tires is the same 15 psi (1 bar).
IMPORTANT INFORMATION
Always use the high position to transport.
2