Demco TP20080 - Manual (Page 4)

7. Install right and left frame mounts. Put proper side up and push 7/16 ” bolt through hole
and start 7/16 ” lockwasher, and hex nut. Start 10mm x 1.25 punch lock nut over factory
stud. Push mount up so angle is fl at on front of frame, and clamp with C-clamp. Snug
previously mentioned fasteners. Drill 5/16
” holes through frame using mount as a template
(three on each mount).
8. Remove top bumper bolt on each side and install brace with 8mm x 1.25 x 25mm
bolt, 8mm lockwasher, and 8mm fender washer. Secure bottom of brace to frame
mount using 3/8
” x 1-1/4 ” bolt, 3/8 ” lockwasher,3/8 ” fl atwasher, and 3/8 ” hex nut.
We require that “
R
Blue” be used on all bolts.