Demco TP20080 User Manual
Page 3
3. Remove bumper cover by removing plastic push fasten-
ers from top side, three bolts from bottom side. Remove
one plastic push fastener from inner fender to bumper
cover, and one bolt from inner fender to bottom of front
fender, on each side.
4. Unplug side marker lights, and pull bumper cover off.
5. Remove one plastic push from inner fender to brace,
which is bolted to frame, on each side. (no picture)
6. From inside of frame out put 7/16
”
x 3
”
bolt thru frame
and slip bushing through outside of frame over 7/16”
bolt. Do this on each side.
NOTE: For Grand Vitara XL.7, 7/16
”
x 3
”
bolt must be
installed from outside of frame inwards. Do this by fi rst
putting a 4
”
long solid wire from inside frame. Slide
bushing through large hole with wire inside of it. Put
frame mount up and put 7/16
”
bolt through mount and
into bushing and bolt will push wire out of the way. Then
install 7/16
”
lockwasher and 7/16
”
hex nut. Proceed to
next step