Echo Bear Cat DL10 - Manual (Page 10)

Debris Loaders 6
ASSEMBLY
2.2 ATTACH BLOWER DISCHARGE
1
2
3
4
5
1. Place the two spacers (3) on the mounting flange of the debris loader frame.
2. Holding the discharge tube (5) in place on the mounting flange, position the lower discharge clamps under the flange
(2).
3. Thread the four 2-3/4" carriage bolts (1) through the lower (2) and upper discharge clamps (5), spacers (3) and
secure with the four knobs (4).
4. To direct the discharge tube (5), loosen all four knobs (4), reposition, and then retighten the knobs.
2.3 FILL THE TANK
Use only those types of fuels that are recommended in
your engine owner’s manual.
To add fuel:
1. Stop engine, wait for all parts to stop moving and
disconnect spark plug wire. Remove key from key
switch. Allow the engine and muffler to cool for at least
three minutes.
2. Clean area around fuel fill cap and remove cap.
3. Using a clean funnel, fill fuel tank to 1/2” below bottom
of filler neck to provide space for any fuel expansion.
Install fuel fill cap securely and wipe up any spilled
gasoline.
WARNING
Gasoline and diesel fuels are highly
flammable and their vapors are explosive.
To prevent personal injury or property
damage:
Store fuel only in approved containers, in
well ventilated, unoccupied buildings, away
from sparks or flames. A container with a capacity of 2
gallons or less with a pouring spout is recommended.
Do not fill the fuel tank while the engine is hot or
running, since spilled fuel could ignite if it comes in
contact with hot parts or sparks from ignition. Do not
start the engine near spilled fuel. Never use fuel as a
cleaning agent. DO NOT MIX OIL WITH FUEL.