Echo Bear Cat SC3305 - Manual (Page 10)

6 3 INCH CHIPPER/SHREDDER
Section
assEmbLY 2
WaRNING
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
Remove items from the shredder area by removing
the discharge screen.
Remove the chipper/shredder and hopper assembly 1.
from the shipping box and pallet.
Install four 5/16" X 3/4" bolts so the head of the bolt is
2.
located on the inside of the hopper. Fasten bolts with
5/16" nylock nuts and 5/16" flat washers.
Assemble the hopper assembly to the frame so the 1.
handle is located above the engine and the opening
is toward the chipper chute.
Install twelve 5/16" X 3/4" bolts so the head of the
2.
bolt is inside the hopper. Fasten bolts with 5/16" flat
washers and 5/16" nylock nuts.
NOT AVAIlABlE ON All MODElS
Place the chipper chute extension onto the chute. 1.
line up the four holes located on the bottom of the
extension and the top of the chute.
Install four 5/16" X 3/4" bolts so the head of the bolt
2.
is located on the inside of the chipper chute. Fasten
bolts with 5/16" nuts. Tighten nut until snug against
the chute extension.
NOT AVAIlABlE ON All MODElS
Place the discharge weldment onto the chipper. The holes 1.
on the weldment should line up with holes on the chipper.
Secure the top of the discharge weldment using one
2.
5/16" x 7-1/2" bolt (narrow door) or one 5/16" x 10" bolt
(wide door) and 5/16" nuts. Tighten to proper torgue
Secure the bottom of the discharge weldment using
3.
two 5/16" x 3/4" bolts and 5/16" nuts. The head of the
bolt should be located inside the discharge assembly.
Tighten to the proper torque.
2.1 INsTaLLING THE HaNdLE
2.2 INsTaLLING THE HoppER
2.3 INsTaLLING THE cHIppER cHuTE
ExTENsIoN
2.4 INsTaLLING dIscHaRGE assEmbLY
HANDLE
HOPPER
CHIPPER
EXTENSION
(WHERE AVAILABLE)
DISCHARGE
ASSEMBLY
(WHERE AVAILABLE)