Drake DSE2 Plus HD Encoder w/QAM Output - Manual (Page 9)

9 937.746.4556 | www.rldrake.com
RF Output: This type “F” connector is a high level (+29.5 dBmV to +45 dBmV), agile 5 to 1002 MHz, multiplexed
output from the DSE2 Plus RF output section.
DC Power Connector: This connector provides the means for connection to the 5 VDC output of the supplied external
power supply.
Component Input 2: These three color coded RCA connectors, Cr (red), Cb (blue), and Y (green), provide the means
to input component video. To input composite video, use the green ‘Y’ connector.
VGA Input 2: This VGA type connector provides the means to input VGA video from a computer or other device with
VGA output.
HDMI Input 2: This connector provides the means to input HDMI video (without HDCP) with optional embedded audio.
Audio Input 2: These two color coded RCA vtype connectors provide baseband audio Left (white) and Right (red)
inputs to the DSE2 Plus.
Closed Caption Input 2: This connector provides the means to input closed captioning. It requires analog composite
video that contains closed captioning.
VGA Loop Output 2: This connector provides VGA video output to a monitor or other equipment requiring VGA input.
It is only active when VGA is input on R4.
Component Input 1: These three color coded RCA connectors, Cr (red), Cb (blue), and Y (green), provide the means
to input component video. To input composite video, use the green ‘Y’ connector.
VGA Input 1: This VGA type connector provides the means to input VGA video from a computer or other device with
VGA output.
HDMI Input 1: This connector provides the means to input HDMI video (without HDCP) with optional embedded audio.
Audio Input 1: These two color coded RCA type connectors provide baseband audio Left (white) and Right (red)
inputs to the DSE2 Plus.
Closed Caption Input 1: This connector provides the means to input closed captioning. It requires analog composite
video that contains closed captioning.
VGA Loop Output 1: This connector provides VGA video output to a monitor or other equipment requiring VGA input.
It is only active when VGA is input on R10.
Status LED: Ethernet Link indicator.
IP Reset: When pushed and held for about 10 seconds, resets the IP address, Usernames, and Passwords to Factory
default values.
Ethernet Connection: This connector provides the means to connect the DSE2 Plus to an Ethernet local area
network or computer for remote control, monitoring, and/or firmware update. It is not recommended that this port be
connected directly to a wide-area network without external access controls, like a VPN or firewall. 1
2
3
4
5
6
7
8
9
Rear Panel Operation
1 2 4 5 3 9 10 11 15 16 17
6 12 7 8 14 13
17
10
11
12
13
14
15
16