DR Power 295171 Gas to Electric Conversion Kit - Manual (Page 2)

7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1
©2011 Country Home Products, Inc. All rights reserved 276331
7. Position the Electric Motor with Pump onto the Frame Mount and secure
with the new Bolts, Washers (one Washer on Bolt side and one on Locknut
side) and Locknuts using two 1/2" Wrenches (Figure 4).
8. Remove the plastic protectors from the Pump Elbow threads.
Note: The angle of the Elbows is set at the factory and should be at the correct
position to connect the Hydraulic Hoses. If however you are unable to connect a
Hose to the Elbow, due to the angle, an adjustment is required. Go to “Elbow
adjustment” at the end of this document. If the Hoses will connect with no
adjustment, continue to the next step.
9. Connect the intake Hose at the Intake Elbow with a 7/8" Wrench (Figure 5).
10. Connect the Pressure Hose at the Elbow with a 19mm Wrench.
Refer to your new Dual-Action Electric Log Splitter Safety and Operating
Instruction manual to cycle and check fluid level before continuing with the
Operating section of the manual.
If you have any questions please contact us at www.DRpower.com or call 1-800-
DR-OWNER (376-9637) for assistance.
Elbow Adjustment (Only perform if the Hose will not reach the
Elbow due to Elbow angle)
These adjustments work for both elbows on the Pump.
Tools and Needed:

24mm Wrench
1. Loosen the Jam Nut with a 24mm Wrench and back it off until it stops
(Figure 6).
2. Screw the Elbow into the Pump all the way so the Washer is against the
Elbow and Pump.
3. Turn the Elbow back to the angle needed to attach the Hose.
Note: Do not turn the Elbow back more than one full turn when adjusting.
4. Tighten the jam nut against the Pump and return to step 8 of the kit
installation above.
Motor
Hardware
Figure 4
Motor
Figure 5
Pressure
Hose
Connection
Intake Hose
Connection
Pump
Figure 6
Jam Nut
Elbow