DR Power 27589 Tray Kit User Manual
DR Power Hardware

Rapidfire™ Tray Kit# 27589
DR
®
RAPIDFIRE™ LOG SPLITTER
TRAY Kit# 27589
These instructions will aid in the installation of the Tray accessory for your
Rapidfiire Log Splitter. Please keep these instructions with your Log Splitter
Safety and Operating Manual for future reference.
Tools and Supplies Needed:
•
Two 9/16" Wrenches
•
Sawhorse
•
Wheel Chocks
1. Remove the Handles by pulling the Handle Pins and removing the Bolts and
Locknuts using two 9\16" Wrenches (Figure 1).
2. Loosen (do not remove yet) the eight Bolts, Flat Washers and Locknuts
securing the two Carriages with two 9\16" Wrenches (Figure 2)
3. Install Wheel Chocks and place a Sawhorse under the front part of the
Frame to lift the Supporting Leg off the ground (Figure 3).
4. Remove the eight Bolts, Flat Washers and Locknuts securing the two
Carriages with two 9\16" Wrenches and store the Carriages.
Note: The Support Leg and Handle Brackets will come off when the forward
Carriage hardware in removed. Store the Handle Brackets with the
Carriages. All Hardware will be reused.
Handles
Figure 1
Pin
Handle
Hardware
Before performing any maintenance procedure or inspection, stop the engine,
wait five (5) minutes to allow all parts to cool. Disconnect the spark plug
wire, keeping it away from the spark plug. Disconnect the Battery Terminals
(Electric start only).
Carriage
Figure 2
Front
Hardware
Rear Hardware
Frame
Sawhorse
Figure 3
Handle
Brackets
Support
Leg