DR Power 32130 Tray Kit User Manual
Removing the cradles

CONTACT US AT www.DRpower.com 1
DR
®
RAPIDFIRE™ LOG SPLITTER
Tray Kit# 32130
These instructions are for installation of the Tray Kit. Please keep these
instructions with your Splitter Safety and Operating Instructions manual for
future reference.
Parts Supplied in Tray Kit (
Figure 1):
Item # Part
# Description
Qty
1 ............. 313631 ............ Table, Log (not shown) ......................... 1
2 ............. 321041 ............ Bolt, Carriage, 3/8-16 X 1", GR5, ZP ..... 4
3 ............. 333331 ............ Nut, Nylon Lock, Flanged, 3/8-16 ......... 4
4 ............. 150431 ............ Bolt, HHCS, 3/8-16 X 1-1/4", GR5 ........ 4
5 ............. 112411 ............ Washer, Flat, 5/16", USS, ZP ................ 4
6 ............. 180811 ............ Washer, Lock, 3/8" ................................ 4
Compare the contents of the Tray Kit with the “Parts Supplied” list above. If
you have any questions please contact us at www.DRpower.com or call 1-800-
DR-OWNER (376-9637) for assistance.
Tools needed:
Large Jack Stand or equivalent
9/16" Wrench
Removing the Cradles
1. Support the end of the Beam with a Jack Stand or equivalent to position the
Beam parallel with the ground.
2. Remove the three Carriage Bolts and Locknuts for each Cradle using a
9/16" Wrench and remove the Cradles (Figure 2).
3. Remove the four Bolts and Locknuts the front Cradle Bracket using two
9/16" Wrenches Install to the end of the Beam with (Figure 3).
4. Remove the four Bolts and Lock Washers securing the Tow Bar using two
9/16" Wrenches and remove the Tow Bar (Figure 4).
4
Figure 1
3
2
5
6
Cradles
Figure 2
Carriage Bolts
and Locknuts
Side
Bracket
Front Cradle
Bracket
Figure 3
Bolts and
Locknuts
Tow Bar
Figure 4
Bolts and
Lock Washers
Before performing this kit installation, stop the engine, wait five minutes to
allow all parts to cool. Disconnect the spark plug wire, keeping it away from
the spark plug. Disconnect the Battery Terminals (Electric start only).