DR Power 32130 Tray Kit User Manual

Page 2

7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1

334541

5. Install the Tow Bar to the end Tray with four Bolts and Lock Washers (from

product package) using two 9/16" Wrenches (Figure 5).

6. For easier alignment in the following step, slightly loosen the Side Bracket

Hardware using a 9/16" Wrench (Figure 6).

7. Position the Tray onto the Side Brackets and install the four Carriage Bolts

and Locknuts (from the tray kit) by hand.

8. Install the four Bolts, Lock Washers and Flat Washers (from the tray kit) to

secure the Tray to the end of the Beam using a 9/16" Wrench (Figure 7).

9. Tighten all remaining Tray hardware using a 9/16" Wrench.

10. The Leg may already be in the down position but if it is not then pull the

Hitch Clip and Clevis Pin from the Leg and fold it to the down position.
Align the holes and secure the Leg with the Clevis Pin and Hitch Clip (Figure
8).

11. Remove the Jack Stand and lower the Splitter onto the Support Leg.

If you have any questions please contact us at www.DRpower.com or call 1-800-
DR-OWNER (376-9637) for assistance.

Tray

Figure 5

Bolts and Locknuts

Support
Leg

Hitch Clip
and Clevis Pin

Figure 8

Support
Leg

Tray

Figure 6

Side Brackets

Bolts and
Locknuts

Bolt, Lock Washer
and Flat Washer

Figure 7

Tray

Beam