Dacor MWDH27 - Manual (Page 10)

8
Installation Instructions
Verifying the Warming Drawer
Operation
Connect power plug to the electrical outlet. 1.
Operate the warming drawer as outlined in the use and 2.
care manual that accompanied this product.
Installation Checklist
WARNING
To ensure a safe and proper installation, the
•
following checklist should be completed by the
installer to ensure that no part of the installation has
been overlooked.
Proper installation is the responsibility of the
•
homeowner. The importance of proper installation of
your warming drawer cannot be overemphasized.
Has the mounting platform been installed according to
□
the instructions on page 6?
Has the a properly grounded, dedicated, three prong
□
electrical outlet been installed for the appliance by a
licensed electrician? See page 6.
Has the chassis been properly fastened to the
□
mounting platform and sides of the cabinet?
See page 7.
Has the drawer been properly installed?
□
Has proper operation
□
been verified?
Have any problems been noted on the warranty card
□
or during the on-line warranty activation? Has the
warranty been activated on-line or the warranty card
filled out completely and mailed?
Re-installing the Drawer
Pull the drawer slides all the way out of the drawer 1.
opening.
Gently lower the drawer between the extended slides 2.
until it is suspended by them.
Slide the back of the drawer mounting brackets under 3.
the drawer mounting clips on the slides.
Push one side of the drawer down onto its locking tab, 4.
until the tab locks into place.
Repeat the same process on the opposite side. 5.
Gently open and close the drawer to make sure that it 6.
is properly installed.
StEP 3: Slide mounting
bracket under clip on slide
Clip on slide
Slide
StEP 4: Push front of
drawer down until tabs lock
into place