Thread mount – Digital Audio Labs Livemix MT-1 Microphone Stand Mount User Manual
Page 2

DIGITAL AUDIO LABS
1266 PARK RD
CHANHASSEN, MN 55317
WWW.DIGITALAUDIO.COM
(952) 401 - 7700
© 2013 DIGITAL AUDIO LABS.
Subject to change without notice.
THREAD
MOUNT
The Mic Stand Thread Mount configuration allows a CS-
DUO to mount on a dedicated microphone stand. This
mounting method is perfect for musicians that don’t
require other stands for microphones or music.
Four captive thread holes on the bottom side of the CS-
DUO allow the personal mixer to mount in two different
positions on the MT-1.
Before you begin, locate these parts of the MT-1:
1. Large circle opening on the bottom side of the
mount
2. 1x 5/8” - 27 nut (secured to MT-1 with V-Clamp
screw.
3. 2x Captive thumbscrews (thread into CS-DUO)
To attach the MT-1 and CS-DUO to your mic stand:
1. Align the large circle opening on the bottom side of the
MT-1 with the top of the microphone stand.
2. Secure the MT-1 by threading the 5/8” - 27 nut until it is
finger tight.
3. To firmly lock the MT-1 in place, hold the microphone
stand pole with one hand while turning the MT-1 with the
other hand.
4. Locate the two captive thread holes on the bottom side
of the CS-DUO personal mixer that are closest to the
front panel. These are the recommended mounting
connections on the CS-DUO for this configuration.
5. While holding the CS-DUO, align the MT-1 captive
thumbscrews with the CS-DUO captive thread holes
mentioned in step 4.
6. Still holding the CS-DUO, thread the thumbscrews into
the CS-DUO by hand. If permanent attachment is desired, the thumbscrews can also
accommodate Flathead and Phillips screwdrivers.
7. Route cables through cable management openings.