Digital Alert Systems DASAMS - Manual (Page 24)

Digital Alert Systems
AMS Installation /Operation & Integration Guide
Revision 1.1 Page 24 of 28
5. In the Maintain
Transmissions
page click
Customize to
enter the
Advanced
Transmission
parameters.
The Customize section
of the system contains
the additional setup
parameters. The
appropriate Value
fields in the Advanced
Transmission
Parameters screen
should be changed as required.
6. Full pathname of ftp Site: Enter the full path to the AMC in the form of
xxx.xxx.xxx.xxx/incoming where the x’s represent the AMC’s IP
address
.
7. filename (no Extension): Default = Alert. Can be modified if necessary,
otherwise leave as default value.
8. ftp User login: Default = anonymous. Can be modified if necessary,
otherwise leave as default value.
9. ftp User password: Default = anonymous. Can be modified if
necessary, otherwise leave as default value.
10. Contact to close to play alert tones (0-7): User selectable. Stations
using the BTI Contact Closure (GPO) unit may choose an open contact to
wire to the MultiPlayer to control audio playback
Optional GPI/O wiring to the AMC:
A. Wire (2-wires) the selected GPO from BTI Attendant Solutions to
one or more of the GPI’s on the MultiPlayer.
B. In the AMC Configuration > GPIO page assign the input to “Play
All” (Note you can label the input “BTI” making it easy to identify
the input source)
C. Click “Update” to save the configuration
11. number of seconds to keep the contact closed: Default = 60. Can be
modified if necessary, otherwise leave as default value
12. Click Close then Close again.
Figure 19 Maintain Transmissions screen for
breaking news
Figure 18 BTI Advanced
Transmission Screen for setting IP
path to AMC. (Note the address
192.168.0.68 is shown as an
example only. Also note the forward
slash / separating the IP and the
folder name “incoming”)