Digi-Star Cab Control 2000/V - Manual (Page 7)

Operators Manual
D3660 5
If you wish to run the self-test on the Cab Control unit, follow steps 1 through 8 under
“Setup Cab Control” on page 4.
If the power supply voltage drops below the (10.5 Volts), the message
, - . , - . , - . , - . %%%%
/ - / - / - / -
and 0 1
0 1 0 1 0 1
will periodically show on the display to alert the operator of the low
battery condition.
NOTE: If
is displayed, the indicator power (not the Cab Control power) is below 10.5
volts.
Warning! Disconnect the Cab Control power cord before
jump-starting or fast-charging the battery.
!
FCCID: OUR-24XTREAM
This device complies with part 15 of the FCC rules. Operation Is subject to the following
conditions:
(1) this device may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesirable operation.
To comply with FCC regulations, this device may be used only with approved antennas. Contact
Digi-Star Customer Support for additional information.
Warning! This equipment is approved only for mobile and base station
transmitting devices, separation distances of (i) 20 centimeters or
more for antennas with gains 6 dbi or (ii) 2 meters or more for
antennas with gains = or > 6dbi should be maintained between the
antenna of this device and nearby persons during operation. To
ensure compliance, operation at distances closer than this is not
recommended.