Digi-Star Cab Control 2000/V - Manual (Page 5)

Operators Manual
D3660 3
The EZ indicator a factory-installed and configured radio that is assigned a unique scale
number (SCL NO). Two indicators cannot operate using the same scale number. The
following setup parameters are required for proper radio operation:
- (Select – )
NOTE: For best performance on systems with six or less indicators, use scales numbered
1 - 6.
Change Scale Number on Indicator Using Long Form Setup
NOTE: Perform this process on the indicator front panel (Do not use Cab Control).
1. Enter the Long Form Setup by holding [Net-Gross] and pushing [On] for three
seconds.
2. Press [Net/Gross] or [Select] to advance to .
3. Press [On] to advance to
4. Press [Net/Gross] or [Select] to set to .
5. Press [On] to save setting and advance to
.
6. Press [Net/Gross] or [Select] to set to desired scale.
7. Hold [Tare] and press [On/Off] to return to indicator operation.
8. Press [On] to save setting and advance to end of menu.