Digi-Star Cab Control 2.4 - Manual (Page 8)

Cab Control 2.4
6
Setting-Up the Cab Control 2.4
The Cab Control 2.4 is setup at the factory. There is one
selection for the
, one for and twelve selections
to enable or disable communications from each of the
twelve available scales.
- Turn audio alarm or .
- Set Cab Control 2.4 to turn off after or
minutes.
- Disable or enable each of the 24 scale selections.
Note: Disable unused scale selections to avoid selecting
scales that are not in use.
Setting up Cab Control 2.4
1.
Follow steps “a” and “b” to enter the “SETUP” menu:
a. Turn the unit off.
b. Hold [Net/Grs], press [On] momentarily and
continue to hold [Net/Grs] for 8 seconds.
and will show on the display followed by the
current setting.
2. Press [Net/Grs] or [Select] to toggle the buzzer or
.
3. Press [On] to save the setting and advance to .
4. Press [Net/Grs] or [Select] to select or .
5. Press [On] to save the setting and advance to the next
selection.
6. Press [Net/Grs] or [Select] to enable (Y) or disable (N)
each of the 24 available scales.
7. Press [On] to save the setting and advance to the next
selection.
8. After scale number 24 has been set, press [On] to exit
or [Net/Grs] to run self-test.