Digi-Star Cab Control 2.4 - Manual (Page 5)

Operators Manual
D3990 3
Turning on the Cab Control 2.4
Press [On].
- A brief and message will be displayed.
- If no signal is received, the indicator will flash NODATA
and the scale number. Example:
.
- If a signal is received, the Cab Control 2.4 display will
match the display on the scale.
- Pressing a key on the Cab Control 2.4 front panel
causes that key-press to be entered on the scale
indicator.
NOTE: To turn Cab Control 2.4 off, press and hold [On/Off]
until is displayed. Scale indicator cannot be
turned “On” or “Off” from the Cab Control 2.4.
Communicating with a Different Truck
1. Press and hold [Net/Grs] for 1.5 seconds to enter the
“select” mode. The Cab Control 2.4 will display the
indicator number that is currently communicating.
2. Press [Select] again (within 3 seconds) until desired
indicator number is displayed.
NOTE: After 3 seconds, the Cab Control 2.4displays the
currently selected scale.
- If a signal is being received, the Cab Control 2.4 display
will match the display on the scale.
- If the desired scale number is not being displayed, see
“Setting Up the Cab Control 2.4” steps 1 through 7 on
page 6.