Diamond Amplification Spec Op User Manual
Page 5
Spec op owner’s manual
(rev 2)
Page 2 of 18
FRONT PANEL
REAR PANEL
MAKING CONNECTIONS
Power. As always, plug your power cable in first.
All DA amps use a corcom design. This allows you to take your amp all over the world and
ensure you’re ready for the voltage you need. Your corcom comes ready for the appropriate
voltage for the country of destination of the amp. If you need to change, you will find
instructions at the end of this manual on changing your corcom for other voltages.
Speakers. Your DA product comes equipped with two speaker jacks. Always ensure, when
connecting speakers, that you use a high quality speaker cable. Never use instrument cable
to connect your amp to speakers and never put effects between your amp and speakers.
If you are using one speaker cabinet, you can plug into either speaker jack. Make sure your
impedance selector is set to the same impedance as the speaker cabinet. If you are unsure
of the impedance of your speaker cabinet, please find out before making your connection.