Diamond Amplification Spec Op - Manual (Page 4)

Spec op owner’s manual
(rev 2)
Page 1 of 18
Welcome to a new world in guitar amplification. Combine the functionality you want with the
tried and true technology of tube tone, wrap that in a completely new approach to the
structure of a high gain sound, and unleash the dynamic range of Diamond Amplification’s
Spec Op.
This manual will walk you through the features, controls and tonal possibilities available to
you. It is highly suggested that you read through this manual in its entirety before dialing in
your new tone! The information in this manual will familiarize you with this amp’s capabilities,
FEATURES
• 100 watts (4 x Svetlana “Winged C” EL34 - 7 x selected 12AX7A-C)
• 2 fully independent channels (Channel 1 - Clean/Channel 2 - Crunch)
• Both Channels feature Volume, Gain, Bass, Middle, Treble, Presence
• Dual Volume/Gain Channel 2 (switchable, allows for two gain settings with 2 volumes
for level adjustment to match volumes)
• Foot selectable boost switch with tube-driven boost (boosts clean channel and both
volume/gain controls on crunch channel). Boost is adjustable from the front panel for
approximately 0 - 20db boost.
• Rear panel low frequency 3-position adjustment switch (allows for changing the
amount and character of the bottom end - effects both channels)
• 4 switch foot controller for direct access to all three volume/gain controls (Channel 1,
Channel 2A, Channel 2B) connected with a 5-pin XLR cable.
• 3 x 1/4" jacks tied to the footswitch controller for controlling through tip to ground
control mechanisms as an alternate to the footswitch controller.
• 110v, 120v, 220v and 230/240v power selection.
• Ohm selector switch for 4, 8 or 16ohm output.
• Blue LED's light the box for a distinctive look on stage, along with a stainless steel
front grille and etched zinc logo.
• All components specifically spec'd and tested by Diamond before inclusion in the
product.
• Independent LED's indicate which volume/gain is active and whether the boost is
engaged.
• Properly designed, tube-driven effects loop (so the loop will automatically engage
when cables are plugged in and disengage when cables are removed).
• Front panel Effects Return control that acts as an overall master when loop is engaged
for quick overall volume adjustment.