DFI CA331-NR - Manual (Page 64)

64
3
BIOS Setup
IDE Configuration
This section is used to configure the IDE drives.
Disabled
Compatible
Enhanced
BIOS SETUP UTILITY
v02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
← → Select Screen
↑↓ Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
IDE Configuration
Mirrored IDER Configuration
SATA#1 Configuration
Configure SATA#1 as
SATA#2 Configuration

Primary IDE Master

Primary IDE Slave

Secondary IDE Master

Secondary IDE Slave

Third IDE Master

Fourth IDE Master

Fifth IDE Master

Fifth IDE Slave
Hard Disk Write Protect
IDE Detect Time Out (Sec)
ATA(PI) 80Pin Cable Detection
Advanced
[Enabled]
[Compatible]
[IDE]
[Enhanced]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
: [Not Detected]
[Disabled]
[35]
[Host & Device]
Mirrored IDER Configuration
Enables or disables the IDER feature.
SATA#1 Configuration / SATA#2 Configuration
The options are Disabled, Compatible and Enhanced.
Configure SATA#1 as
IDE
This option configures the Serial ATA drives as Parallel ATA storage devices.
RAID
This option allows you to create RAID or Intel Matrix Storage configuration on
Serial ATA devices.
AHCI
This option allows the Serial ATA devices to use AHCI (Advanced Host Con-
troller Interface).