DFI LR100-N16D - Manual (Page 30)

30
2
Hardware Installation
The VGA port is used for connecting a VGA monitor. Connect the monitor’s 15-pin
D-shell cable connector to the VGA port
. After you plug the monitor’s cable con-
nector into the VGA port, gently tighten the cable screws to hold the connector
in place.
BIOS Setting
Configure the onboard VGA in the Chipset menu of the BIOS. Refer to chapter 3
for more information.
Driver Installation
Install the graphics driver. Refer to chapter 4 for more information.
VGA Port
VGA