DFI CD101-N - Manual (Page 19)

www.dfi .com
19
Chapter 2 Hardware Installation
Chapter 2
RJ45 LAN Ports
The LAN ports allow the system board to connect to a local area network by means of a
network hub.
BIOS Setting
Configure the onboard LAN in the Chipset menu (“South Bridge Configuration” submenu) of
the BIOS. Refer to chapter 3 for more information.
Driver Installation
Install the LAN drivers. Refer to chapter 4 for more information.
LAN 1
Features
• 2 Intel 82574L Gigabit Ethernet controllers ; or 2 Intel ® I210 PCI Express Gigabit Ethernet
controllers (optional)
LAN 2
USB Ports
The USB device allows data exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
The system board is equipped with four onboard USB 2.0/1.1 ports (USB 0-1/2-3). The one
10-pin connector allow you to connect 2 additional USB 2.0/1.1 ports (USB 4-5). The additional
USB port may be mounted on a card-edge bracket. Install the card-edge bracket to an avail-
able slot at the rear of the system chassis and then insert the USB port cables to a connector.
BIOS Setting
Configure the onboard USB in the Advanced menu (“USB Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
Driver Installation
You may need to install the proper drivers in your operating system to use the USB device.
Refer to your operating system’s manual or documentation for more information.
USB 2
10
VCC -Data +Data GND Ke
y
VCC
-Data +Data GND N. C.
9 1
2
USB 1
USB 0
USB 4-5
USB 2.0
USB 3
LAN 1
LAN 2
USB 2.0