DFI CM100-C - Manual (Page 35)

www.dfi .com
35
Chapter 3 BIOS Setup
Chapter 3
W83627DHG Super IO Configuration
This section is used to configure the I/O functions supported by the onboard Super I/O chip.
Set Parameters of Serial
Port 1 (COMA).
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.11.1210. Copyright (C) 2011 American Megatrends, Inc.
W83627DHG Super IO Confi guration
W83627DHG Super IO Chip
 Serial Port 1 Confi guration
 Serial Port 2 Confi guration
WatchDog
Advanced
W83627DHG
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.11.1210. Copyright (C) 2011 American Megatrends, Inc.
Serial Port 1 Confi guration
Serial Port
Device Settings
Change Settings
Advanced
[Enabled]
IO=3F8h; IRQ=4;
[Auto]
Serial Port 1 Configuration
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit
Serial Port
Enables or disables the serial port (COM).
Change Settings
Selects an optimal setting for the super I/O device.
Device Mode
Changes the serial port mode. Selects high speed or normal mode.
Watchdog
Enable or disable Super I/O watchdog timer.
Enable or Disable Serial
Port (COM)
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.11.1210. Copyright (C) 2011 American Megatrends, Inc.
Serial Port 2 Confi guration
Serial Port
Device Settings
Change Settings
Device Mode
Advanced
[Enabled]
IO=2F8h; IRQ=3;
[Auto]
[Standard Serial Po...]
Serial Port 2 Configuration
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save Changes and
Reset
ESC: Exit