DFI CM100-C - Manual (Page 21)

www.dfi .com
21
Chapter 2 Hardware Installation
Chapter 2
SATA 3
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the
Serial ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“IDE Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
SATA (Serial ATA) Connectors
SATA 3.0 6Gb/s
• 4 Serial ATA ports
- 4 SATA 3.0 ports with data transfer rate up to 6Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
• Supports RAID 0 and RAID 1
SATA 2
SATA 1
SATA 0
7
RXN GND TXP TXN GND
1
RXP GND
Features
Cooling Fan Connectors
The fan connectors are used to connect cooling fans. The cooling fans will provide adequate
airflow throughout the chassis to prevent overheating the CPU and system board components.
BIOS Setting
The Advanced menu (“Hardware Health Configuration” submenu) of the BIOS will display the
current speed of the cooling fans. Refer to chapter 3 for more information.
System fan
1
3 Sense
Power
Ground
CPU fan
3
1 Ground
Power
Sense