Supported software – DFI NP951-B16C User Manual
Page 102
102
4
Supported Software
1. Enter the preferred lan-
guage and other prefer-
ences then click Next.
Installing the AHCI Driver During Windows 7 / Windows Vista Installation
The AHCI driver must be installed during Windows 7 / Windows Vista installation.
This is required in order to be able to install the operating system onto a hard
drive that is configured in AHCI mode.
Note:
The illustrations below were captured from the Windows 7 operating sys-
tem. Except for slight differences in their screen appearance, the instal-
lation procedure is also the same for Windows Vista.
When you insert the operating system’s installation disc into an optical drive, the
message Press any key to boot from CD or DVD will appear. Press Enter.
2. Click Install Now.
See also other documents in the category DFI Hardware:
- ES300 (2 pages)
- U340 Series (2 pages)
- VS Series (2 pages)
- BT9A3 (57 pages)
- CD9A3 series (60 pages)
- CD905-B series (68 pages)
- BT700 (71 pages)
- BT700 (71 pages)
- CD905-B2600 (63 pages)
- CD905-B2800 (63 pages)
- CP908-B (104 pages)
- CR908-B (68 pages)
- HR908-B (66 pages)
- HU968 (86 pages)
- ML905-B11C/B16C (76 pages)
- KB968 (68 pages)
- LR905-B18S (93 pages)
- OT905-B series (61 pages)
- CM960-B (1 page)
- CM901-B (72 pages)
- CP900-B (130 pages)
- NP905-B16C (125 pages)
- CR900-B (73 pages)
- CR902-BL (75 pages)
- CR901-B (69 pages)
- CR960-QM77 (81 pages)
- HM920-QM87 (98 pages)
- G5C900-B106 (118 pages)
- HM960-QM87 (101 pages)
- HM961-QM87 (95 pages)
- HR900-B (102 pages)
- HR902-BL (75 pages)
- FS700 (17 pages)
- QB702-B (47 pages)
- QB700-B (73 pages)
- COM100-B (32 pages)
- QB701-B (73 pages)
- NP900-B16C (121 pages)
- COM101-BAT (32 pages)
- COM630-B (50 pages)
- COM330-B (57 pages)
- Q7-100 (31 pages)
- Q7-951 (46 pages)
- Q7A-551 (23 pages)
- Q7X-151 (30 pages)