DFI COM100-B - Manual (Page 20)

www.dfi.com Chapter 2 Hardware Installation
20
Chapter 2
LVDS LCD Panel Connector
LCD/Inverter Power Connector
The system board allows you to connect a LCD Display Panel by means of the LVDS
LCD panel connectors and the LCD/Inverter power connectors. These connectors trans-
mit video signals and power from the system board to the LCD Display Panel.
Refer to the right side for the pin functions of these connectors.
Jumper Settings
Refer to the “Jumper Settings” section in this chapter for settings relevant to the LCD
panel.
LVDS LCD Panel Connector LCD/Inverter Power Connector
Pins Function Pins Function
1 GND 2 GND
3 LVDS_Out3+ 4 LVDS_Out7+
5 LVDS_Out3- 6 LVDS_Out7-
7 GND 8 GND
9 LVDS_Out2+ 10 LVDS_Out6+
11 LVDS_Out2- 12 LVDS_Out6-
13 GND 14 GND
15 LVDS_Out1+ 16 LVDS_Out5+
17 LVDS_Out1- 18 LVDS_Out5-
19 GND 20 GND
21 LVDS_Out0+ 22 LVDS_Out4+
23 LVDS_Out0- 24 LVDS_Out4-
25 GND 26 GND
27 LVDS_CLK1+ 28 LVDS_CLK2+
29 LVDS_CLK1- 30 LVDS_CLK2-
31 GND 32 GND
33 LVDS_DDCCLK 34 N.C.
35 LVDS_DDCDAA 36 N.C.
37 Panel Power 38 Panel Power
39 Panel Power 40 Panel Power
Pins Function
1 GND
2 GND
3 Panel Inverter Brightness Voltage Control
4 Panel Power
5 +3.3V
6 Panel Backlight On/Off Control
7 +12V
8 +12V
COM1
COM2
I C
COM2
COM1
LVDS LCD Panel
LCD/Inverter power
1
8
2 1
40 39
Note:
DFI board's LVDS connector: Hirose DF13-40DP-1.25V(91)/40P/1.25mm; cable side
connector: Hirose DF13-40DS-1.25C.