Rear panel i/o ports, Chapter 2 rear panel i/o ports, 5v~19v dc-in – DFI COM100-B User Manual
Page 15
www.dfi.com
Chapter 2 Hardware Installation
15
Chapter 2
Rear Panel I/O Ports
The rear panel I/O ports consist of the following:
• 5V~19V DC-in jack
• 2 Serial COM ports
• 1 DisplayPort
• 1 LAN port
• 2 USB 3.0 ports
• 4 USB 2.0 ports
• Line-in/Surround, Line-out and Mic-in/Center+Subwoofer jacks
USB 3.0
0-1
COM 2
Line-out
COM 1
DisplayPort
LAN
DC-in jack
USB 2.0
2-5
Mic-in/
Center+Subwoofer
Line-in/Surround
This jack provides maximum of 60W power and is considered a low power solution. Connect
a DC power cord to this jack. Use a power adapter with 19V DC output voltage. Using a volt-
age higher than the recommended one may fail to boot the system or cause damage to the
system board.
5V~19V DC-in
DC-in
COM1
COM2
I C
COM2
COM1
See also other documents in the category DFI Hardware:
- ES300 (2 pages)
- U340 Series (2 pages)
- VS Series (2 pages)
- BT9A3 (57 pages)
- CD9A3 series (60 pages)
- CD905-B series (68 pages)
- BT700 (71 pages)
- BT700 (71 pages)
- CD905-B2600 (63 pages)
- CD905-B2800 (63 pages)
- CP908-B (104 pages)
- CR908-B (68 pages)
- HR908-B (66 pages)
- HU968 (86 pages)
- ML905-B11C/B16C (76 pages)
- KB968 (68 pages)
- LR905-B18S (93 pages)
- OT905-B series (61 pages)
- CM960-B (1 page)
- CM901-B (72 pages)
- CP900-B (130 pages)
- NP905-B16C (125 pages)
- CR900-B (73 pages)
- CR902-BL (75 pages)
- CR901-B (69 pages)
- CR960-QM77 (81 pages)
- HM920-QM87 (98 pages)
- G5C900-B106 (118 pages)
- HM960-QM87 (101 pages)
- HM961-QM87 (95 pages)
- HR900-B (102 pages)
- HR902-BL (75 pages)
- FS700 (17 pages)
- QB702-B (47 pages)
- QB700-B (73 pages)
- QB701-B (73 pages)
- NP900-B16C (121 pages)
- COM101-BAT (32 pages)
- COM630-B (50 pages)
- COM330-B (57 pages)
- Q7-100 (31 pages)
- Q7-951 (46 pages)
- Q7A-551 (23 pages)
- Q7X-151 (30 pages)