DFI NP905-B16C - Manual (Page 121)

121
4
Supported Software
Installing the AHCI Driver During Windows XP Installation
The AHCI driver must be installed during the Windows
®
XP instal-
lation using the F6 installation method. This is required in order to
install the operating system onto a hard drive when in AHCI mode.
1. Start Windows Setup by booting from the installation CD.
2. Press when prompted in the status line with the ‘Press
F6 if you need to install a third party driver’ message.
3. Press to “Specify Additional Device”.
4. At this point you will be prompted to insert a floppy disk con-
taining the AHCI driver. Insert the provided floppy diskette.
5. Locate for the drive where you inserted the diskette then
select AHCI controller that corresponds to your BIOS setup.
Press to confirm.
You have successfully installed the driver. However you must con-
tinue installing the OS. Leave the floppy disk in the floppy drive until
the system reboots itself because Windows setup will need to copy
the files again from the floppy disk to the Windows installation fold-
ers. After Windows setup has copied these files again, remove the
floppy diskette so that Windows setup can reboot as needed.