Standby power led, Cooling option, Chapter 3 cooling option – DFI KB968 User Manual
Page 26
www.dfi .com
Chapter 3 Hardware Installation
26
Chapter 3
Cooling Option
Heat Sink with Cooling Fan
• “1” and “2” denote the locations of the thermal pads designed to contact
the corresponding components that are on KB968.
Top View of the Heat Sink
Bottom View of the Heat Sink
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto KB968.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
1
2
Standby Power LED
This LED will light when the system is in the standby mode.
Standby
Power LED
See also other documents in the category DFI Hardware:
- ES300 (2 pages)
- U340 Series (2 pages)
- VS Series (2 pages)
- BT9A3 (57 pages)
- CD9A3 series (60 pages)
- CD905-B series (68 pages)
- BT700 (71 pages)
- BT700 (71 pages)
- CD905-B2600 (63 pages)
- CD905-B2800 (63 pages)
- CP908-B (104 pages)
- CR908-B (68 pages)
- HR908-B (66 pages)
- HU968 (86 pages)
- ML905-B11C/B16C (76 pages)
- LR905-B18S (93 pages)
- OT905-B series (61 pages)
- CM960-B (1 page)
- CM901-B (72 pages)
- CP900-B (130 pages)
- NP905-B16C (125 pages)
- CR900-B (73 pages)
- CR902-BL (75 pages)
- CR901-B (69 pages)
- CR960-QM77 (81 pages)
- HM920-QM87 (98 pages)
- G5C900-B106 (118 pages)
- HM960-QM87 (101 pages)
- HM961-QM87 (95 pages)
- HR900-B (102 pages)
- HR902-BL (75 pages)
- FS700 (17 pages)
- QB702-B (47 pages)
- QB700-B (73 pages)
- COM100-B (32 pages)
- QB701-B (73 pages)
- NP900-B16C (121 pages)
- COM101-BAT (32 pages)
- COM630-B (50 pages)
- COM330-B (57 pages)
- Q7-100 (31 pages)
- Q7-951 (46 pages)
- Q7A-551 (23 pages)
- Q7X-151 (30 pages)