DFI DS912-OT Manual - Manual (Page 69)

69
3
BIOS Setup
Super IO Confi guration
This section is used to confi gure the I/O functions supported by the onboard
Super I/O chip.
Set parameters of Serial
Port 0 (COMA).
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.11.1210. Copyright (C) 2011 American Megatrends, Inc.
Super IO Confi guration
Super IO Chip
 Serial Port 0 Confi guration
 Serial Port 1 Confi guration
Case Open Beep
Watchdog
AC Power Loss
Advanced
Winbond W83627DHG
[Disabled]
[Disabled]
[Turns OFF]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Case Open Beep
Set this fi eld to Enabled to allow the system to alert you of a chassis intru-
sion event.
Watchdog
This fi eld is used to enable or disable the Watchdog Timer function.
AC Power Loss
Turns Off
When power returns after an AC power failure, the system’s power is off. You
must press the Power button to power-on the system.
Turns On
When power returns after an AC power failure, the system will automatically
power-on.
Former-Sts
When power returns after an AC power failure, the system will return to the
state where you left off before power failure occurs. If the system’s power
is off when AC power failure occurs, it will remain off when power returns.
If the system’s power is on when AC power failure occurs, the system will
power-on when power returns