D-Link DCS-900W - Manual (Page 6)

6
EthernetCable Connector
The DCS-900W features an RJ-45 connector for connections to 10Base-T Ethernet cabling
or 100Base-TX Fast Ethernet cabling (which should be Category 5 UTP cable). The port
supports the NWay protocol, allowing the DCS-900W to automatically detect or negotiate
the transmission speed of the network.
DC Power Connector
The DC power input connector is labeled DC 5V with a single jack socket to supply
power to the DCS-900W.
Reset Button
Reset will be initiated when the reset button is pressed once and Power LED begins to
flash.
Factory Reset will be initiated when the reset button is pressed continuously for three
seconds or when the Power LED begins to light up. Release the reset button and the
Power LED will begin to flash indicating that the DCS-900W’s settings are reverting
back to the factory settings. The IP address will also return to the default setting of
192.168.0.20.
Connections
Rear Panel view
Ethernet Cable
Connector
Reset Button
802.11b Antenna
802.11b Antenna
The DCS-900W features an 802.11b wireless antenna for 802.11b wireless connectivity
to your existing wireless network. The DCS-900W can be used in conjuction with an
802.11b compliant access point or router.
DC Power Connector