Devolo dLAN 200 AV - Manual (Page 9)

|
Connection and startup 9
| devolo dLAN 200 AV |
Make sure that all of the dLAN 200 AV devices that you want to add to your net-
work are also connected to the power supply grid. After about 20 minutes, a
dLAN 200 AV switches into stand-by mode unless there is an active network
device (e. g. computer) connected to the Ethernet interface. dLAN 200 AV
devices in stand-by mode are not accessible over the power supply grid. As soon
as network device (e.g. computer) connected to the Ethernet interface is
switched on again, your dLAN 200 AV can also be reached again via the electric
supply.
2.3 Connecting the dLAN 200 AV
In this section, we will show you how to connect the dLAN 200 AV to a com-
puter.
ቢ With the computer running use the included network cable to connect the
dLAN 200 AV to an Ethernet port of the computer.
ባ Plug the dLAN 200 AV into a convenient power socket.
ቤ Continue with the installation of the devolo dLAN 200 AV software. For
more information, refer to the chapter on 'devolo dLAN 200 AV software'.
No drivers are required for running the dLAN 200 AV.
ETH Link/Act Is lit red whenever an Ethernet connection of 100 Mbps exists;
flashes red when data are being sent or received.
Ethernet port This is the connection point on the dLAN 200 AV for connect-
ing it to a computer or another network device with the net-
work cable (included).