Datatek DT-7000 Utilities - Manual (Page 16)

U t i l i t i e s - D T 6 b a c k u p , D T 6 r e l o a d , D T 6 u p g r a d e – R e l e a s e 3 . 0
D T 7 b a c k u p , D T 7 r e l o a d
02/04/10 Datatek Applications Inc. 16
4.5 DT6 UPGRADE
This utility requires the minimum level or higher of the platform software (see Table 1: Minimum Platform
Software, page 5).
4.5.1 U SAGE FOR TCP/IP E NDPOINTS
Syntax: dt6upgrade -i [-v] [-d] [-V] [–p] [-P] -sa
[–t]
Where:
-v Print Version of the Utility, then exit
-d Connection Debug (verbose) print enable
-V Abbreviated Debug (verbose) showing runtime progress of the utility
-p Password for logging into the DT product (Default is “initial”)
-P
As an alternative to supplying the –p option, -P causes dt6reload to prompt for
the unit password when it is needed. The password is not echoed.
-i Specifies that a TCP/IP connection is to be used
-t Override the standard TCP/IP Port number (Default is 1023)
-sa
(Required) Use direct file transfer from the host to the unit. This requires the minimum
level or higher of the platform software.
The IP address of the DT product console
The filename including its directory string, if necessary, on this host containing the
new software package.
The –sa option must be given in the command line.