Datatek Enhanced Security Guide - Manual (Page 8)

I P-CommKit En hanced Securit y G uide
11/29/05 Datatek Applications Inc. 8
Here, utm_ip_address is the address assigned to the UTM. Note that dkipd will use the
name associated with the address, if possible. If your host connects to several UTMs,
you should see this message repeated for each UTM IP address.
If you did not enable encryption on the UTM, you will see the following message:
Jun 5 15:27:21 (10202) UTM module utm_ip_address encryption
disabled
If you did not purchase a license to use the IP-CommKit Enhanced Security Feature, or
did not register your software with a software key that enables the feature, you will see
the following output:
Jun 5 15:27:21 (10202) Software key does not have encryption
feature enabled
If you see no messages containing the word encryption, you are probably running a
release of IP-CommKit that does not support the Enhanced Security Feature. Follow the
procedure in the IP-CommKit Installation and Administration Guide for checking the
release number of the IP-CommKit software. If the release is not 1.0.13 or greater, you
must upgrade your IP-CommKit software to use the Enhanced Security Feature.