Dukane Projectors - Manual (Page 6)

3
In order to protect the optical head during shipment, it and the mast
have been packed apart from the base.
1. Remove the optical head/mast assembly and base from the
shipping carton.
2. On plastic models, depress stage opening latch tabs on front of
the stage and lift off stage (Step 1). Place stage aside.
3. Find the Allen head screw and the Allen wrench. (On plastic base
models, find the Allen head screw, washer, wing nut and Allen
wrench).
4. Take the mast and identify the lower end which has no plastic
cap.
5. Position the mast open end so the 3 holes fit over the two
alignment posts with the center hole being open (Step 2).
6. Insert the Allen screw from outside the unit into the mast. Turn
screw tight with fingers. Further tighten with the 1/8’ Allen
wrench. On plastic base models, use the wing nut and washer on
the inside of unit to tighten the Allen head screw (Step 3).
7. Replace stage on top of unit by aligning the rear edge. Push front
down to lock into place.
SETUP/ASSEMBLY
Open stage.
S TEP 1 —
Fix Mast with
washer and
wing nut.
S TEP 3 —
Position Mast
on posts.
S TEP 2 —
Inside of Base
Washer and
wing nut
Allen screw