Daktronics Sportsound SSR-100 Quick Start Guide - Manual (Page 3)

Sportsound SSR-100 Quick Start Guide 3 of 3
DD2753515 Rev 1
23 January 2015
201 Daktronics Drive PO Box 5128, Brookings, SD 57006-5128
Tel: 1-800-DAKTRONICS (1-800-325-8766) Fax: 605-697-4746
Web: www.daktronics.com/support
Optional Wireless Receiver System Operation Wireless Microphone & Bodypack Operation
Power
ON/OFF
Power
ON/OFF
IR Window
Single Receiver
1. Ensure all transmitters are powered off. Press the power button to
turn on the receiver if it is not already on.
2. Press menu until “scan” displays on the LCD.
3. Press enter to start frequency scan. When scan is complete, Group
and Channel will display on the LCD.
Network Receivers
1. Ensure all transmitters are powered off. Turn on all receivers and
wait one minute to allow time to connect to the network.
2. Press menu on one receiver until group number flashes.
3. Use the arrow buttons to select a group to scan.
4. Press enter, wait for channel, and then press enter again
5. Press menu until “network scan” displays on the LCD.
6. Press enter twice to deploy channels to other receivers.
Power IR Window
a
e
b c
d g f h
The unit displays the following information:
a) Transmitter Battery Life
b) TV Channel
c) Frequency
d) Group Number
e) Channel Number
f) RF Signal Strength
g) Transmitted Audio Level
h) Gain Level
Note: Perform a scan on all of the wireless units just minutes before the
game! If a scan is performed too far ahead of time, frequencies set up by
the media later on may interfere with previously configured settings.
1. Open the battery cover. Insert new or fully-charged AA batteries prior to
each use, and always have spares on hand.
2. Power on the transmitter device.
3. Hold the transmitter device up close to one receiver in the rack, ensuring the
infrared (IR) windows are aligned.
4. Press sync on the receiver; “good” will display if sync was successful.
5. Repeat steps 1-4 to pair another transmitter device with an additional
receiver (if present).
Note: Plug the referee mute switch into the jack on top of the bodypack unit
and plug headphones/lapel mic into the referee mute switch.
Verify Reception: With a transmitter and the receiver both turned on and
having matching GROUP and CHANNEL numbers, the RF meter on the receiver
should be indicating signal. Speak into the microphone and the audio meter
should indicate signal presence.