Daktronics CH-1036H - Manual (Page 5)

Introduction 1-1
Section 1: Introduction
1.1
How To Use This Manual
This manual explains the installation and maintenance of the CH-1036H auto racing display
system. Setup of other control equipment or operation of the CHTS-300 timing console are
not covered in this manual. For questions regarding the safety, installation, operation or
service of this system, please refer to the telephone numbers listed on the cover page of this
manual.
Important Safeguards:
1. Read and understand these instructions before installing.
2. Do not drop the control console or allow it to get wet.
3. Be sure the scoreboard is properly grounded with a ground rod at the display
location.
4. Disconnect power to the display when it is not in use.
5. Disconnect power when servicing the display.
6. Do not modify the display structure or attach any panels or coverings to the
display without the written consent of Daktronics, Inc.
The box below illustrates Daktronics drawing numbering system. The drawing number
“7087-P08A-69945” is how Daktronics identifies individual drawings. This number is
located in the lower-right corner of the drawing. This manual refers to drawings by listing the
last set of digits and the letter preceding them. In the example below, the drawing would be
referred to as Drawing A-69945. Referenced drawings are inserted at the end of the first
section which references them.
1.2 Display
Overview
Reference Drawing: Display, CH-1036H........................................ Drawing A-51724
Drawing A-51724 shows a Daktronics CH-1036H auto racing display. The CH-1036H
display along with the use of the Daktronics CHTS-300 timing console will display the lap
number and lap time on the display.