Introduction, How to use this manual, Introduction -1 – Daktronics H-813S User Manual
Page 5: 1 how to use this manual -1
Section 1: INTRODUCTION
Reference Drawings: Model ID, H-XX13S.............................................. Drawing A-39709
Model ID, H-XX13B.............................................. Drawing A-39708
System Layout ..................................................... Drawing A-32236
Your Daktronics Hockey Scoring System is one of a family of display systems designed to offer
simple installation, easy readability, and reliability. Microprocessor control assures consistent
operation and accuracy.
Six display models, H-813S, H-2013S, H-2813S, H-813B, H-2013B, and H-2813B are covered by this
manual, which is provided to assist you in installing and operating your system, and as an aid to you if
the display needs service.
1.1
How To Use This Manual
This manual explains the installation, operation, maintenance and troubleshooting of the East
Carolina University display system. For questions regarding the safety, installation, operation
or service of this system, please refer to the telephone numbers listed on the cover page of this
manual.
Important Safeguards:
1. Read and understand these instructions before installing.
2. Do not drop the control console or allow it to get wet.
3. Be sure the display is properly grounded with a ground rod at the display location.
4. Disconnect power to the display when it is not in use.
5. Disconnect power when servicing the display.
6. Do not modify the display structure or attach any panels or coverings to the
display without the written consent of Daktronics, Inc.
Daktronics identifies manuals by an ED number located on the cover page of each manual.
Any reference manuals called out in this manual will be identified by its ED number. For
example, this manual would be referred to as ED-3364.
The box below illustrates Daktronics drawing numbering system. This number is located in
the lower-right corner of the drawing. Drawings in the manual are identified by listing the last
set of digits and the letter preceding them. In the example below, the drawing would be
referred to as Drawing A-69945. Referenced drawings are inserted at the end of the section
that references them.
Introduction
1-1