Daktronics H-813S - Manual (Page 12)

2-2 Installation
2.2.1 Power
Each display is equipped with a 120 VAC, 3-prong plug. Provide two grounded
receptacles and plug it in. Actual maximum display power consumption is as follows:
Model No. Max. Power
------------- ---------------
H-813S 300 watts
H-813B 400 watts
H-2013S 700 watts
H-2013B 950 watts
H-2813S 950 watts
H-2813B 1300 watts
The control console requires a grounded 120 VAC receptacle for power. Power
requirement is less than one amp.
2.2.2 Signal
Route conduit and cable between display location(s) and the control location. Use
paired cable, minimum 22 AWG, connecting the cable to the junction box at the
control end. Connect the phone plugs provided to the display end of the cable. Insert
plugs into the jacks on the top of the display. Make connections according to the
drawing on the next page, and chart below.
DISPLAY LOCATION CONTROL
LOCATION
Red Red Center Section
Black Black
Red White
Left Section
Black Green
Red Orange
Right Section
(Bar Digit Only)
Black Blue