Daktronics WiFi Communication - Manual (Page 10)

4 Installation
2.1 Signal Termination Between Displays
Primary - Mirror
Figure 2: Mirror Cable
Most displays are shipped as either a single Primary display or
two displays in a 2V, Primary – Mirror configuration.
The Primary - Mirror (2V) quick connect cable is used to
terminate signal between two displays. The cable goes from the
Signal OUT jack (J34) on the primary display to Signal IN jack
(J32) on the mirror display.
Multiple Primary Displays
A display network consisting of multiple primary displays can
be established with the aid of Ethernet switches.
An Ethernet switch is installed in the first primary display.
Signal cable is connected to the Ethernet switch before passing
through to the display’s controller. Additional signal cable is
routed from the Ethernet switch to the controller(s) inside the
additional display(s).
Figure 3: Ethernet Switch
Refer to the Ethernet Switch Installation quick guide
(DD1442218) for more information.